Abstract
Self-potential (SP) measurements were conducted at Mt. Tsukuba, Japan, which is a nonvolcanic mountain, to infer groundwater flow system in the mountain. Survey routes were set around the northern slope, and the reliability of observed SP anomaly was checked by using SP values along parallel survey routes; the error was almost within 10 mV. The FFT analysis of the spatial SP distribution allows us a separation of raw data into two components with shorter and longer wavelength. In the shorter (altitudinal) wavelength than ∼200 meters, several positive SP peaks of more than 100 mV in magnitude are present, which indicate shallow perched water discharges along the slope. In the regional SP pattern of longer wavelength, there are two major perturbations from the general trend reflecting the topographic effect. By comparing the SP and hydrological data, the perturbation around the foothill is interpreted to be caused by heterogeneous infiltration at the ground surface. The perturbation around the summit is also interpreted to be caused by heterogeneous infiltration process, based on a simplified numerical modeling of SP. As a result, the SP pattern is well explained by groundwater flow and infiltration processes. Thus, SP data is thought to be very useful for understanding of groundwater flow system on a mountain scale.
Highlights
Spatial distribution of self-potential or spontaneous potential (SP), which is time-invariant natural electrical potential, has been observed at the ground surface along a topographic slope
Note that voltage difference between routes A and B was less than 10–20 mV, which is thought to be due to small difference in the electrode position between these two survey routes except the start and end points
The fast Fourier transform (FFT) was applied to SP values at 512 points spaced with altitude interval of about 1.286 m
Summary
Spatial distribution of self-potential or spontaneous potential (SP), which is time-invariant natural electrical potential, has been observed at the ground surface along a topographic slope. Topographic effect on SP is thought to be caused by subsurface fluid flow along the slope through electrokinetic coupling (e.g., [4]). Characteristic potential difference across the electrical double layer, is commonly negative for typical crustal rocks in water of pH higher than ∼2 [6], the pore fluid flow carries positive charges with it; so a negative correlation between the hydraulic head and the streaming potential is expected. Yasukawa and Mogi [7] conducted numerical calculations of groundwater flow and associated streaming potential and confirmed a negative correlation between the altitude and SP value, which has observable amplitude on International Journal of Geophysics the slope surface. SP can be generated by other effects such as thermoelectric coupling [8], electrochemical effects (diffusion potential, redox potential, etc.; e.g., [8, 9]), SP along a mountain slopes is thought to be mainly caused by the electrokinetic effects
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
