Implication of carbohydrazide chemosensors in selective sensing of Fe(III) and construction of molecular devices

Abstract

Listen

Translate article

Two new and two reference sensors L1-L2 and R1-R2, respectively, based on the hydrazide core were synthesized in good yields (70–86 %). A variety of analytical methods, including NMR, HRMS, and single-crystal XRD, were used to characterize these sensors. Cyclic voltammetry, UV–visible absorption, and emission spectroscopies were then used to confirm the electrochemical and photophysical characteristics of these sensors. Moreover, theoretical calculations at the level of DFT and TD-DFT were carried out to compare the experimental findings with the theoretical ones. The sensors were found to exhibit luminescence attributed to singlet ligand-centered (1LC) transitions. Based on their luminescent properties and the previous literature reports where structurally analogous sensors have been used for the detection of metal ions, these sensors were investigated as selective chemosensors for Fe(III) detection, with a "turn-off" fluorescence behaviour in a binding stoichiometry of 1:1 = sensor:M(III) [M = Fe(III)] with a limit of detection of 2.71–39 µM, or 0.15–2.81 ppm. The mechanistic details regarding the sensing of Fe(III) ion by the sensors was provided by NMR, IR, XPS and UV-visible absorption spectroscopic studies. To increase the usefulness of the sensors, L2 was also applied for the successful fabrication of the molecular logic gate and molecular lock keypad. Paper strip test and sensing of Fe(III) contaminated water by the sensors accounted for the practical applicability of the sensors in real life.