Abstract

Sequestration of CO2 within stable mineral carbonates (e.g., CaCO3) represents an attractive emission reduction strategy because it offers a leakage-free alternative to geological storage of CO2 in an environmentally benign form. However, the pH of aqueous streams equilibrated with gaseous streams containing CO2 (pH < 4) are typically lower than that which is required for carbonate precipitation (pH > 8). Traditionally, alkalinity is provided by a stoichiometric reagent (e.g., NaOH) which renders these processes environmentally hazardous and economically unfeasible. This work investigates the use of regenerable ion-exchange materials to induce alkalinity in CO2-saturated aqueous solutions such that the pH shift required for mineralization occurs without the need for stoichiometric reagents. Na+-H+ exchange isotherms (at [H+] = 10−8–10−1 M) and rates were measured for 13X and 4A zeolites and TP-207 and TP-260 organic exchange resins in batch equilibrium and fixed-bed exchange experiments, respectively. At solutions equilibrated with CO2 at 1.0 atm (pH = 3.9), H+ exchange capacities for the materials were similar (1.7–2.4 mmol H+/g material) and resulted in pH increases from 3.9 to greater than 8.0. Multi-component mixtures using Ca2+ and Mg2+ cations (at 10−3–10−1 M) in CO2-saturated water were used to probe competitive ion exchange. The presence of divalent cations in solution inhibited H+ exchange, reducing capacities to as low as 0.2 mmol H+/g for both resins and zeolites. Dynamic H+ exchange capacities in fixed-bed ion exchange columns were similar to equilibrium values for resins (∼1.5 mmol/g) and zeolites (∼0.8 mmol/g) using inlet solutions that were equilibrated with gaseous streams of CO2 at 1.0 atm. However, exchange kinetics were limited by intraparticle diffusion as indicated by the increased rate parameters with increasing inlet flow rates (20–160 cm3 min−1). Experimental calcite precipitation from mixing the alkaline CO32−-rich water solution obtained from the ion-exchange column with a simulated liquid waste stream solution achieved thermodynamic maximum yields. The results from these studies indicate that ion exchange processes can be used as an alternative to the addition of stoichiometric bases to induce alkalinity for the precipitation of CaCO3, thereby opening a pathway toward sustainable and economic mineralization processes.

Highlights

  • From 1975 to 2018, atmospheric CO2 levels have dramatically increased from 250 to 410 ppm

  • H+ exchange capacities at solution equilibrium concentrations of 10–4 M H+ range from 1.7 to 2.4 mmol H+ (g material)−1, with the organic resins exhibiting higher uptake capacities than the zeolites under more acidic solutions. These data demonstrate the ability of these ion exchange materials to sufficiently shift the pH of aqueous solutions to conditions that favor carbonate precipitation via compact flow processes (i.e., 50 g of material required to increase the pH of 1 L of water from 4 to 10; described in more detail in Dynamic Ion Exchange)

  • CaCO3 yields will be significantly affected by total Ca2+ concentrations, whereas purities will significantly be affected by total Mg2+ and Fe2+/3+ concentrations as the results have shown. The results from these studies indicate that ion exchange processes can be used as an alternative to the addition of stoichiometric bases to induce alkalinity for the precipitation of CaCO3

Read more

Summary

Introduction

From 1975 to 2018, atmospheric CO2 levels have dramatically increased from 250 to 410 ppm. The International Energy Outlook reported that world energy carbon dioxide (CO2) emissions would reach 35 gigatons CO2 equivalent (Gt CO2e) by 2020 (IEA, 2020b) Of these emissions, thirty-two percent (17.8 Gt CO2e) have been generated during primary energy consumption of oil and gas in the transportation and industrial sectors (IEA, 2019; IEA, 2020a). In the United States, transportation emissions (totaling 1.9 Gt CO2e in 2018 Nyquist and Ruys, 2009; IEA, 2019) are generated via distributed sources and must be mitigated via direct air capture technology, industrial power generation [1.0 Gt CO2e in 2018 from direct combustion of fossil fuels for energy (Nyquist and Ruys, 2009; IEA, 2019)] can be considered as point sources of CO2. The low carbon future envisioned to combat climate change will require new technologies for CO2 emissions mitigation from primary energy users and during oil and gas recovery

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call