Abstract

This paper describes and assesses a decentralized solution based on a wireless sensor-actuator network to provide primary frequency control from demand response in power systems with high wind energy penetration and, subsequently, with relevant frequency excursions. The proposed system is able to modify the electrical power demand of a variety of thermostatically-controlled loads, maintaining minimum comfort levels and minimizing both infrastructure requirements and primary reserves from the supply side. This low-cost hardware solution avoids any additional wiring, extending the wireless sensor-actuator network technology towards small customers, which account for over a 30% share of the current power demand. Frequency excursions are collected by each individual load controller, considering not only the magnitude of the frequency deviation, but also their evolution over time. Based on these time-frequency excursion characteristics, controllers are capable of modifying the power consumption of thermostatically-controlled loads by switching them off and on, thus contributing to primary frequency control in power systems with higher generation unit oscillations as a consequence of relevant wind power integration. Field tests have been carried out in a laboratory environment to assess the load controller performance, as well as to evaluate the electrical and thermal response of individual loads under frequency deviations. These frequency deviations are estimated from power systems with a high penetration of wind energy, which are more sensitive to frequency oscillations and where demand response can significantly contribute to mitigate these frequency excursions. The results, also included in the paper, evaluate the suitability of the proposed load controllers and their suitability to decrease frequency excursions from the demand side in a decentralized manner.

Highlights

  • Maintaining the balance between power generation and demand is a key issue in power system operation

  • A set of tests in a laboratory environment has been carried out to evaluate the suitability of the proposed Wireless Sensor-Actuator Network (WSAN) solution under the presence of frequency deviations

  • An Elgar SW5250A power source is used as an arbitrary waveform generator, allowing us to emulate real power grid disturbances, including frequency excursions or voltage dips

Read more

Summary

Introduction

Maintaining the balance between power generation and demand is a key issue in power system operation. The Pacific Northwest National Laboratory (PNNL) developed a device called the “Grid Friendly Controller” that helps the power system be secure and reliable by monitoring extremely low-frequency signatures and turning off certain appliances, such as refrigerators, air-conditioners and heaters [7,8] Another similar prototype was commercially promoted by Responsive Load Ltd (London, UK). A signal from the central control system is sent by radio signals to the demand side in order to trigger load shedding in real time This solution provided a high system reliability, a significant rolling blackout prevention and low operating costs. The test laboratory environment and results considering frequency excursions from power systems with high wind power penetration are given, including thermal and electrical data collected from thermostatically-controlled loads.

General Description
Load Controller Hardware Description
Load Controller Software Description
Laboratory Test Environment
Case Studies and Results
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call