Implement and soil condition effects on tillage-induced erosion

Abstract

Water, wind, or tillage-induced soil erosion can significantly degrade soil quality. Therefore, understanding soil displacement through tillage translocation is an important step toward developing tillage practices that do not degrade soil resources. Our primary objective was to determine the effects of soil condition (i.e. grassland stubble versus previously tilled soil), opening angle, and harrow speed on soil translocation. A second field study also conducted on a Lixisol but only in the stubble field, quantified displacement effects of mouldboard ploughing. The field studies were located 12 km South of Évora, Portugal. Soil displacement or translocation after each tillage operation in both studies was measured using aluminium cubes with a side length of 15 mm as ‘tracers’. Offset angles for the harrow disk were 20°, 44° and 59°; tractor velocities ranged from 1.9 to 7.0 km h −1 and tillage depth ranged from 4 to 11 cm. The depth of mouldboard ploughing was approximately 40 cm with a wheel speed of 3.7 km h −1. The translocation coefficients for the two implements were very different averaging 770 kg m −1 for the mouldboard plough and ranging from 9 to 333 kg m −1 for the harrow disk. This shows that the mouldboard plough was more erosive than the harrow disk in these studies. All three variables (soil condition, opening angle, and tillage velocity) were critical factors affecting the translocation coefficient for the harrow disk. Displacement distances were the largest for compacted soils (stubble field), with higher opening or offset angles, and at higher velocities. The results also showed significant correlation for (a) mean soil displacement in the direction of tillage and the slope gradient and (b) soil transport coefficient and the opening angle. Our results can be used to predict the transport coefficient (a potential soil quality indicator for tillage erosion) for the harrow disk, provided tillage depth, opening angle, and tool operating speed are known.