Abstract

The excessive damage and high defect density generated during ion-beam etching of crystalline Si is characterized by Rutherford backscattering, photoluminescence, and transmission electron microscopy. In samples etched at room temperature, a highly damaged surface layer (d≊5 nm) with a large concentration of noble gas atoms is detected and analyzed using Rutherford backscattering in axial channeling geometry. Point defects due to the low-energy noble gas ion implantation are produced within a depth of 100 nm and deeper, and are monitored by their characteristic photoluminescence. The intensity of the noble-gas-defect photoluminescence is studied for different ion-beam energies (200–2000 eV) and crystal orientations. A threshold to produce the defects can then be determined, leading to an estimate of the number of vacancies contained in the noble gas defect. Annealing of etched samples at 650 °C causes the formation of different new photoluminescent centers. Although little is known about the structure of these defects, it is observed that the defects effectively getter copper. Further annealing of the Ar-etched samples at 1050 °C causes the formation of Ar bubbles with an average diameter of about 5 nm.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.