Abstract
Objective To evaluate whether breast density influences the sensitivity of a computer-assisted detection (CAD) system for the detection of breast cancer. Material and methods We prospectively studied 8750 digital mammograms with an associated CAD system. We used BI-RADS criteria to classify breast density. We calculated the overall sensitivity of the radiologist and of the CAD system, as well as the sensitivity for each projection and type of finding in relation to the mammographic density of the breast. Finally, we analyzed the interval carcinomas. We used SPSS 11 for all statistical analyses . Results The overall sensitivity of the CAD system was 88.5% (95% CI: 83.2-92.7%), and the overall sensitivity of the radiologist was 93.5% (95% CI: 84.4%-95.5%). The sensitivity of the craniocaudal view was 81.6% (95% CI: 76.5-90.7%) vs 76.5% (95% CI: 69.3-89.3%) for the mediolateral oblique view. The sensitivity for microcalcifications was 98.6% (95% CI: 96.5-99.7%), and the sensitivity for masses 83.4% (95% CI: 81.2-91.7%). We detected discrepancies smaller than 20% both for microcalcifications present in the four types of densities and for masses with densities 1 and 2. In masses with density 3 the discrepancy was 20.8% and in those with density 4 it was 55%. The CAD system failed to mark only 9.1% (9/94) of the cancers presenting as masses. Half of the interval carcinomas were found in type 4 density and 75% manifested as masses, asymmetries, and distortions. The CAD system had marked 35.7% of the carcinomas. Conclusions The craniocaudal view was more sensitive, although this difference was not statistically significant. The sensitivity of CAD was high for microcalcifications in all four density types; however, CAD's sensitivity for masses was low in density types 3 and 4. The CAD system only failed to mark 9.1% of the cancers presenting as masses but was not sensitive for the other two radiological findings included in this marking. Half of the interval carcinomas occurred in type 4 densities and 35.7% had been marked by the CAD sysem.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.