Abstract
AbstractInjection moldings with weld lines were produced in glass reinforced polypropylene grades differing in filler content using a two‐gated hot runner injection mold. The skin‐core microstructure developed during injection molding was qualitatively analyzed by means of optical and scanning electronic microscopy techniques. The load bearing capacity of the moldings was assessed by uniaxial tensile‐impact and biaxial instrumented falling dart impact tests. Microhardness was also used to ascertain the possibility of using it as a simple nondestructive technique for characterizing glass fiber‐reinforced injection moldings. The properties were monitored at various points to evaluate their variation at the bulk and the knit region. The biaxial impact test highlights the 10‐fold reduction of the impact strength caused by the weld line. POLYM. ENG. SCI., 2009. © 2009 Society of Plastics Engineers
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
