Abstract
Measures exist to adjust tailpipe NOx emissions to assigned values, for example cooled exhaust gas recirculation (EGR) or a selective catalytic reduction (SCR) catalyst in conjunction with urea. The situation is quite different with soot when use of a trap is not feasible for reasons of cost, space requirements and maintenance. Due to the highly complex soot formation and oxidation process, soot emissions cannot be targeted as easily as NOx. So, how can soot be kept within the limits? In principle, soot can be controlled by allocating sufficient oxygen and establishing good mixing conditions with vaporized fuel. The most effective measures target the injection system, e.g., increasing injection pressure, applying multiple injections, optimizing nozzle geometry. To investigate the impact of very high injection pressure on soot, an advanced injection system with rail pressure capability up to 3000 bar and a Bosch injector was installed at the Large Engines Competence Center (LEC) in Graz. Full load and part load operating points at constant speed and in accordance with the propeller law were investigated at the test bed to quantify the impact of high injection pressure on soot emissions. Test runs were conducted with both SCR and EGR while varying injection timing and air–fuel ratios. Use of a statistical method, design of experiments (DOE), helped reduce the number of tests. Optical investigations of the spray and combustion were conducted. The goal was to obtain soot concentration history traces with the two color method in order to better understand how soot originates and to be able to calibrate 3D CFD (computational fluid dynamics) FIRE spray models for use with injection pressures of up to 3000 bar. Very low soot emissions can be achieved using high pressure injection, even when EGR is applied. DOE results provide a clear picture of the relationships between the parameters and can be used to optimize set values for the whole speed and load range. A reliable spray break up model can be used in further 3D CFD simulation to investigate how to reduce soot emissions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.