Abstract

The hydrophilicity of cellulose nanocrystals (CNCs) is a major challenge for their processing with hydrophobic polymers and matrices. As a result, many surface modifications have been proposed to hydrophobize CNCs. The authors showed in an earlier study that grafting alcohols of different chain lengths onto the surface of CNCs using toluene diisocyanate (TDI) as a linker can systematically hydrophobize CNCs to a water contact angle of up to 120° depending on the alcohol chain length. Then, the hydrophobized CNCs were used to mechanically reinforce poly(butylene succinate) (PBS), which is a hydrophobic polymer. As a result of hydrophobization, PBS/CNCs interfacial adhesion and the composite mechanical properties significantly improved with the increasing CNC contact angle. Continuing on these results, this paper investigates the impact of CNC surface properties on the crystallization behavior of PBS using differential scanning calorimetry (DSC). The results showed that the crystallization temperature of PBS increased from 74.7 °C to up to 86.6 °C as a result of CNC nucleation activity, and its value was proportionally dependent on the contact angle of the CNCs. In agreement, the nucleation activity factor (φ) estimated using Dobreva and Gutzow’s method decreased with the increasing CNC contact angle. Despite the nucleation action of CNCs, the rate constant of PBS crystallization as estimated using the Avrami model decreased in general as a result of a prevailing impeding effect. This decrease was minimized with increasing the contact angle of the CNCs. The impeding effect also increased the average activation energy of crystallization, which was estimated using the Kissinger method. Moreover, the Avrami exponent (n) decreased because of CNC addition, implying a heterogeneous crystallization, which was also apparent in the crystallization thermograms. Overall, the CNC addition facilitated PBS nucleation but retarded its crystallization, and both processes were significantly affected by the surface properties of the CNCs.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.