Impact of sand and filler materials on the hydration behavior of calcium aluminate cement

Abstract

AbstractIn earlier work, we have observed discrepancies relating to the early hydration of calcium aluminate cement (CAC) when comparing data from heat flow calorimetry of CAC paste with results from mortar strength tests using the crushing method. Here, we investigated on this phenomenon and found that the sand which is used as a filler exerts a major influence on CAC hydration resulting in acceleration. Furthermore, in particular fine filler materials such as, for example, microsilica, fine limestone powder, and especially α‐ and γ‐Al2O3 also produced a strong hydration accelerating effect which is dependent on their specific surface area. The mechanism underlying the acceleration is that under alkaline conditions their negative surface charge attracts calcium ions as was confirmed via inductively coupled plasma atomic emission measurements. Such a layer generates favourable conditions for the nucleation of CAC hydration products (C‐A‐H phases). The resulting crystalline hydrates which form on the surface of the filler particles submerged in CAC cement pore solution were visualized via SEM imaging. This way, specifically selected fillers can significantly accelerate CAC hydration and save precious lithium salts which are commonly used to boost the early strength of CAC.