Abstract

ABSTRACTIn the present study, biodiesel production from the crude cotton-seed oil (CSO) and its feasibility to be used as fuel in compression ignition engine was analysed. Single-stage transesterification at molar ratio of 8:1 on crude CSO yielded 94% of cottonseed biodiesel (CBD). Gas chromatogram/mass spectrometry analysis revealed the presence of 19.5% unsaturated and 80.5% saturated esters in cotton seed biodiesel. Taguchi approach identified the stable fuel blend with oxygenate concentration. Increased oxygen concentration up to 20% were also analysed to understand the variation. Higher peak in-cylinder pressure was observed in D80CBD20 fuel blend. Diesel–biodiesel blend with oxygenate significantly affected the ignition delay and also resulted in varied exhaust gas temperature. D80CBD20nB10 showed an increase in brake thermal efficiency, whereas D80CBD20 exhibited higher brake specific energy consumption at full load. Carbon monoxide, hydrocarbon and smoke emission was found to be high in diesel with higher oxides of nitrogen in D80CBD20nB10. This experimental investigation finally revealed that, D80CBD20nB10 improved the combustion and performance characteristics with minimal emissions.Abbreviations ASTM: American Society for Testing and Materials; BP: brake power; BSEC: brake specific energy consumption; BTE: brake thermal efficiency; CBD: cottonseed biodiesel; CI: compression ignition; CO: carbon monoxide; CO2: carbon dioxide; CSO: cottonseed oil; DEE: diethyl ether; DOE: design of experiments; EGT: exhaust gas temperature; FTIR: Fourier transform infrared spectrometry; GC/MS: gas chromatogram/mass spectrometry; HC: hydrocarbon; HRR: heat release rate; HSDI: high speed direct injection; IDI: indirect injection; KOH: potassium hydroxide; MFB: mass fraction burned; NaOH: sodium hydroxide; NMR: nuclear magnetic resonance; N2O: nitrous oxide; NO: nitric oxide; NO2: nitrogen dioxide; NOx: oxides of nitrogen; ROHR: rate of heat release; ROPR: rate of pressure rise; SOC: start of combustion; aTDC: after top dead centre; bTDC: before top dead centre

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.