Impact of Micro-Indentation on Hardness and Indentation Depth of Ni-Cr Super Alloys

Abstract

ABSTRACT A material’s (metal, composite, polymer, etc.) behaviour is greatly influenced by the indentation hardness and elastic modulus during any operation (sliding, fretting, turning, etc.). To measure the micromechanical properties of surfaces, subsurfaces and coated thin layers of materials, depth-sensing measurement indentation techniques are most commonly used. The present study aims to develop a compressive model to investigate the influence of indentation parameters on the indentation hardness and indentation depth of Ni-Cr superalloy during indentation experiments. Experiments were conducted based on model L18 (21*32) full factorial design with a mixed orthogonal array using a microhardness tester. The experiments revealed that indentation hardness values show a normal indentation size effect with respect to indentation load. Indentation depth values increase with the increase in indentation load. Taguchi's approach and the regression analysis were used to model the indentation hardness and indentation depth with respect to indentation parameters. Analysis of variance was employed to check the effect of input parameters on performance outputs. The experimental and predicted values show a good degree of proximity. However, indentation load (79.22% and 52.34%) was found to be the most dominant parameter affecting indentation hardness and indentation depth, respectively, followed by dwell time.