Impact of in-seam drilling performance on coal seam gas production and remaining gas distribution

Abstract

Drilling horizontal wells in low permeability coal seams is a key technology to increase the drainage area of a well, and hence, decrease costs. It’s unavoidable that some parts of the horizontal section will be drilled outside the targeted coal seam due to unforeseen subsurface conditions, such as sub-seismic faulting, seam rolls, basic geosteering tools, drilling practices and limited experiences. Therefore, understanding the impact of horizontal in-seam drilling performance on coal seam gas (CSG) production and remaining gas distribution is an important consideration in drilling and field development plans. This study presents a new workflow to investigate the impact of horizontal in-seam performance on CSG production and gas distribution for coal seams with different porosity, permeability, permeability anisotropy, initial gas content (GC), initial gas saturation and the ratio of in-coal length to in-seam length (RIIL). First, a box model with an area of 2 km × 0.3 km × 6 m was used for conceptual simulations. Reduction indexes of the cumulative gas production at the end of 10 years of simulations were compared. Then, a current Chevron well consisting of a vertical well and two lateral wells, was selected as a case study in which the impact of outside coal drilling on history matching and remaining gas distribution were analysed. Results show that the RIIL plays an increasing role for cases with decreasing permeability or initial gas saturation, while it plays a very similar role for cases with varied porosity, permeability anisotropy and GC. The size and location of outside coal drilling will affect the CSG production and remaining gas distribution.