Abstract
AbstractTiAlN coatings were deposited on AA1050 and AA5083 aluminium alloys by high‐velocity oxy‐fuel (HVOF) spray process and evaluated for their mechanical and slurry erosion performance. In comparison to base alloys, the mechanical properties were found to enhance upon coating. The effect of working parameters namely impingement angle, impact velocity, erodent size and erodent feed rate on the slurry erosion wear rate has been investigated. The slurry erosion wear rate of the uncoated samples was found to decrease with an increase in the impingement angle whereas for coated samples the slurry erosion wear rate first increased, reached to a maximum value at 60° and then decreased with further increase in the impingement angle. For uncoated and coated samples the slurry erosion wear rate was found to increase with an increase in impact velocity, erodent size and erodent feed rate. Finally, the morphology of the eroded surfaces was analyzed using scanning electron microscopy and the possible erosion mechanisms have been studied.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
