Abstract
The scope of this paper was to examine the effects of the ECAP procedure on the machinability of aluminium (EN AW-6082) based on turning tests. The behaviour of the ECAP material was investigated and compared to the as-received (AR) material. Since limited information on the machinability of ECAP materials is available, it was necessary to conduct an evaluation on basis of the untreated material. For this purpose, a defined range of cutting parameters, which were raised based on recommendations of the tool manufacturer were used for the first experiments. In order to analyse the effects of ECAP on the machinability the following comparative criteria were pulled up: the quality of the machined surfaces, appearing forces and chips produced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
