Abstract
The world experience of using palm oil as a fuel for diesel engines was considered. The influence of the mixture composition on the indices of the injection process at a constant value of the active stroke of the plunger and the mass cyclic feeding of the mixture, corresponding to the nominal cyclic feeding in the case of using only diesel fuel is analyzed. A comparative analysis of the change in the parameters of spraying of diesel fuel mixtures and palm oil fractions from 0% to 60% is performed depending on the specific parameters of the fuel supply equipment and the mixture (working stroke of plunger, cyclic feed and heat input). It is shown that changes in the fuel supply equipment parameters when using mixed fuels based on palm oil are not required, since the corresponding change in the volume cyclic feed and active stroke of the plunger with a change in the proportion of palm oil in the mixture to 60% does not exceed 3%. According to the requirements of the standard, these deviations are within acceptable limits.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
