Impact of dialyzer membrane flux on metal clearance in hemodialysis patients

Abstract

Deficiency of essential trace elements (such as Cu or Zn) and accumulation of potentially toxic trace elements (as Cd or Pb) are both known to have adverse effects in hemodialysis (HD) patients. Up to our knowledge, no studies about the permeability of low and high flux polysulfone membranes on metal ions during hemodialysis are available. Therefore, the aim of the present study was to address this issue. Forty one hemodialysis patients (19 were using high flux polysulfone membrane while the remaining were using low flux one) participated in the study. Blood levels of Cu, Zn, Cd and Pb were determined by graphite furnace atomic absorption spectrometry among HD patients, before and after dialysis session, as well as among matched 40 healthy persons. Blood concentrations of Cu and Zn in the whole hemodialysis group was significantly lower than those of the healthy control group, on the other hand the toxic metals (Cd and Pb) levels were observed to be significantly higher among HD patients compared to the normal persons. Among the hemodialysis group, there were no significant differences between the low and high flux dialyzer groups in terms of pre-dialysis blood levels of Cu, Zn, Cd and Pb. In addition, significantly decreased levels of all metal ions were observed after dialysis sessions using either low or high flux membranes. An exception was Pb which did not show any difference between pre-dialysis and post-dialysis values in the low flux groupIn conclusion Zn and Cu deficiencies should be considered in the treatment of these patients. High flux membranes are more efficient than low flux ones in removing excess Cd and Pb. Therefore, when high flux membranes are used, chelation therapy might not be required for Cd and Pb overload.