Abstract

Simple SummaryIn forensic entomology, blow flies are often the first insects to arrive to decomposing remains. The development rates of blow flies are used to estimate the minimum amount of time between death and discovery of the remains, or post-mortem interval (PMI). When there are multiple species of flies interacting on the same remains, there could be changes in the development of the flies. We tested the development of three different species of blow flies in different combinations at different temperatures and measured the development and the rate of growth. One species (Lucilia sericata) grew larger when it developed with the species Phormia regina at certain temperatures. The larvae of Calliphora vicina gained weight slower when interacting with P. regina and P. regina grew faster when interacting with these two other species. Due to these differences in the development rates of the flies, depending on the species they are interacting with, more research is needed to further examine other species combinations and temperatures.Estimates of the minimum post-mortem interval (mPMI) using the development rate of blow flies (Diptera: Calliphoridae) are common in modern forensic entomology casework. These estimates are based on single species developing in the absence of heterospecific interactions. Yet, in real-world situations, it is not uncommon to have 2 or more blow fly species developing on a body. Species interactions have the potential to change the acceptance of resources as suitable for oviposition, the timing of oviposition, growth rate, size and development time of immature stages, as well as impacting the survival of immature stages to reach adult. This study measured larval development and growth rate of the blow flies Lucilia sericata (Meigen, 1826), Phormia regina (Meigen, 1826) and Calliphora vicina Robineau-Desvoidy (Diptera: Calliphoridae) over five constant temperatures (15, 20, 25, 30, 35 °C), in the presence of conspecifics or two-species heterospecific assemblages. Temperature and species treatment interacted such that L. sericata larvae gained mass more rapidly when in the presence of P. regina at 20 and 30 °C, however only developed faster at first instar. At later stages, the presence of P. regina slowed development of L. sericata immatures. Development time of C. vicina immatures was not affected by the presence of P. regina, however larvae gained mass more slowly. Development time of P. regina immatures was faster in the presence of either L. sericata or C. vicina until third instar, at which point, the presence of L. sericata was neutral whereas C. vicina negatively impacted development time. Phormia regina larvae gained mass more rapidly in the presence of L. sericata at 20 °C but were negatively impacted at 25 °C by the presence of either L. sericata or C. vicina. The results of this study indicate that metrics such as development time or larval mass used for estimating mPMI with blow flies are impacted by the presence of comingled heterospecific blow fly assemblages. As the effects of heterospecific assemblages are not uniformly positive or negative between stages, temperatures or species combinations, more research into these effects is vital. Until then, caution should be used when estimating mPMI in cases with multiple blow fly species interacting on a body.

Highlights

  • To estimate the minimum Post-mortem Interval using insect evidence, there are two general approaches; one method uses the predictable rates of development of blow flies (Diptera: Calliphoridae) [1,2,3] and the other uses the predictable changes in community composition in the succession of insects through decomposition [4,5]

  • Phormia regina took less time to develop at all temperatures tested when compared to L. sericata and C. vicina, whether developing with conspecifics or heterospecifics

  • Development time to subsequent stages was longer when L. sericata developed with P. regina, for time to third instar at 25 ◦C, time to pupation at 15 ◦C and time to adult emergence at 25 ◦C

Read more

Summary

Introduction

To estimate the minimum Post-mortem Interval (mPMI) using insect evidence, there are two general approaches; one method uses the predictable rates of development of blow flies (Diptera: Calliphoridae) [1,2,3] and the other uses the predictable changes in community composition in the succession of insects through decomposition [4,5]. Blow fly species have different growth and developmental rates, which have been measured for numerous species including: Lucilia sericata Meigen [6,7,8,9,10,11], Calliphora vicina RobineauDesvoidy [6,8,10,12,13], and Phormia regina Meigen [6,8,14,15]. Numerous studies provide examples of variable development within species of blow flies This may be a result of different methods such as food source, density, constant versus fluctuating temperatures, or different geographic populations [7,11,16,17,18]. Greater awareness of this issue is being addressed in the forensic entomology community through validation studies that compare estimates of mPMI using different developmental data [19]

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call