Abstract

 Chatter seems throughout the metallic reducing method as a result of resonance resulting from the interaction of the prominent natural frequencies of the gadget with the frequency of chip serration. Chatter leaves a lousy floor finish on the part and negatively affects dimensional tolerances, decreased productiveness, immoderate device wear and damaged device-device components. This paper provides an progressive approach to chatter suppression throughout turning manner by way of offering extremely-thin steel rubber laminates between carbide insert device and tool holder via growing the stiffness of the device. The dynamic behavior of the workpiece and device with laminates are simulated the usage of ANSYS and investigated experimentally. it's miles obvious that with the introduction of rubber brass laminates among tool and device holder the amplitude of vibration of tool decreased and thereby floor finish of workpiece advanced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
