Impact of Brushing Protocols on Dentin Abrasion Caused by Different Abrasive Slurries.

Abstract

To determine the impact of the brushing protocol on dentin wear by comparing continuous to intermittent brushing, with the same total time of brushing. Dentin specimens (n = 120) were evently distributed into six groups (A-F). The samples were brushed with slurries of different relative dentin abrasivity (RDA): Groups A+B (Sident 2480-1; RDA 85), groups C+D (Zeodent 113; RDA 67), and groups E+F (Zeodent 103; RDA 174). Groups A+C+E were brushed continuously (25 min) with one slurry preparation, while groups B+D+F were brushed intermittently (25 x 1 min) with a renewal of the slurry after each sequence. Dentin wear was determined using surface profilometry and statistically analysed with ANOVA and post-hoc tests. Neither the mode of brushing (p = 0.72) nor the interaction (p = 0.18) of the brushing mode with the type of abrasive particles had a significant influence on the abrasive dentin wear. Only the type of abrasive particles had a statistically significant influence on abrasive dentin wear (p < 0.001). The mode of brushing (continuously or intermittently) has no influence on abrasive dentin wear.