Abstract
We have performed nitrogen and phosphorus co-implants at room temperature to obtain high n-type carrier concentration layers in SiC. An inductive heating RTA furnace has been used for the activation annealing. The influence of the temperature ramp parameters such as rise/decrease temperature speed and intermediate annealing steps on the dopant activation rate and surface morphology have been investigated. A reduction of the temperature ramp slope reduces the surface roughness by 50%. Inclusion of a pre-activation annealing step at low temperatures (1300°C) further reduces the surface roughness. However, the use of slower ramps or an intermediate annealing step during ramp up reduces the free carrier concentration. The faster the ramp up, the higher the activation rate and the resulting doping. We also demonstrate that the inclusion of a postactivation annealing at intermediate temperatures (1150°C) reduces significantly the surface roughness. In addition, the use of this post-annealing treatment does not degrade the activation rate nor the carrier Hall mobility, and activation rates close to 100% have been obtained.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
