Abstract
Hadfield steel matrix composite, reinforced by high-chromium (Cr) cast iron bars, was fabricated by inserting high-Cr alloy flux-cored welding wires into Hadfield steel molten at 1500 °C. The characteristics for water-quenched composite were investigated and compared with those of reference Hadfield steel. The results show that flux-cored welding wires could be melted by heat capacity of Hadfield steel molten and transformed into high-Cr cast iron bar reinforcements after solidification. The reinforcements of water-quenched composite consist of martensite, eutectic M7C3 carbides and residual austenite. With the increasing of impact energy, the impact wear rate of the composite firstly decreases, and then increases slightly, therefore, the composite is more available to the conditions of low and medium impact energy. The reason is it can combine fully advantages of the outstanding toughness of Hadfield steel, and high hardness of high-Cr cast iron.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.