IMMOBILIZATION OF COBALT DISULFOPHTHALOCYANINATE ONTO POLYMETHYLOLACRYLAMIDE

Abstract

Different character of usage the porphyrins and their analogs immobilized on carrier polymers stimulates an increased interest in the synthesis and research of physico-chemical properties of porphyrin-polymer immobilizates. In this paper the peculiarities of a synthesis of water-soluble polymer systems containing cobalt disulfophthalocyaninate with the components of a different ratio are described. The methylolation reaction of polyacrylamide to immobilize cobalt disulfophthalocyaninate onto water-soluble carrier polymer has been carried out. It is known that heating polymethylolacrylamide or its solutions leads to the formation of three-dimensional structures with ether and methylene bridges. Therefore, initially the conditions for the preparation of polymethylolacrylamide with preservation of its water solubility were selected. It was found to obtain a water-soluble polymethylolacrylamide, it is necessary that the initial concentration of polyacrylamide in water did not exceed 2% by weight. The immobilization of phthalocyanine metal complex onto the modified polyacrylamide was carried out in two ways. The first is the interaction of the phthalocyanine metal complex with methylated polyacrylamide. The second is functionalization of polyacrylamide and the immobilization of phthalocyaninate metal complex onto the polymer in one-step. The introduction conditions of the cobalt disulfophthalocyaninate introduced influenced the formation of cross-linked structures in the synthesized samples. The introduction of macroheterocycle as a powder was found to promote the formation of insoluble compounds in aqueous media. Therefore, phthalocyanine metal complex was introduced into the system as 1% aqueous solution. The immobilization of the phthalocyanine metal complex onto a carrier polymer has been realized through the formation of hydrogen bonds between the methylol groups of polymethylolacrylamide and sulfo groups of the phthalocyanine metal complex and it was due to coordination interaction between the functional groups of the polymer and metallophthalocyanine as well. The amount of bound cobalt disulfophthalocyanine in the samples was determined by the electronic absorption spectra of the solutions of immobilized phthalocyanine metal complex onto the polymer. The mass content of immobilized cobalt disulfophthalocyaninate onto the polymer in the samples obtained by one-step is greater than in case of the samples obtained in two steps, the ratio of the initial reagents being the same.