Imaging with surface-related multiples to overcome large acquisition gaps

Abstract

Abstract To get the best result for seismic imaging using primary reflections, data with densely-spaced sources and receivers are ideally preferred. However, dense acquisition can sometimes be hindered by various obstacles, like platforms or complex topography. Such areas with large data gaps may deter exploration or monitoring, as conventional imaging strategies would either provide poor seismic images or turn out to be very expensive. Surface-related multiples travel along different paths compared to primaries, illuminating a wider subsurface area and hence making them valuable in case of data with large gaps. We propose different strategies of using surface-related multiples to get around the problem of imaging in the case of a large data gap. Conventional least-squares imaging methods that incorporate surface-related multiples do so by re-injecting the measured wavefield in the forward-modelling process, which makes it still sensitive to missing data. We introduce a ‘non-linear’ inversion approach in which the surface multiples are modelled from the original source field. This makes the method less dependent on the receiver geometry, therefore, effectively exploiting the information from surface multiples in cases of limited illumination. However, such an approach is sensitive to the knowledge of the source properties. Therefore, we propose a ‘hybrid’ method that combines the non-linear imaging method with the conventional ‘linear’ multiple imaging method, which further improves our imaging result. We test the methods on numerical as well as field data. The results indicate substantial removal of artefacts in the image derived from linear imaging methods due to incomplete data, by exploiting the surface multiples to a maximum extent.