Abstract

The hydrodynamics of a gas–liquid–solid fluidised bed bioreactor with a low density biomass support (matrix density smaller than that of water) was investigated. In particular, a minimum fluidisation air velocity Ugf and an air holdup ϵg were measured in a bioreactor with KMT® (Kaldnes Miljotechnologi AS) particles used as biomass support. It was found that values of Ugf depended on the ratio of bed (settled) volume to bioreactor volume (Vb/Vr) and the mass Mbp of cells grown on the particles. For a given mass Mbp, the values of Ugf increased with an increase in the ratio of (Vb/Vr). The values of Ugf were strongly affected by the mass Mbp and decreased with an increase in Mbp. There was a critical ratio (Vb/Vr)cr above which movement of the whole bed was impossible: the particles either remained at the top of the bioreactor or settled at its bottom. The values of (Vb/Vr)cr for which this was happening depended on the mass Mbp and decreased with an increase in Mbp.It was established that the air holdup ϵg depended on the air velocity Ug, the ratio (Vb/Vr) and the mass Mbp. For a given ratio (Vb/Vr) and mass Mbp, the values of ϵg increased with an increase in the air velocity Ug. The optimal ratios (Vb/Vr)o for which the largest values of ϵg were obtained depended on the mass Mbp. The values of (Vb/Vr)o decreased with an increase in Mbp. It was also established that the values of ϵg obtained in a bioreactor with the KMT® particles were approximately 40% larger than those reported in the literature for bioreactors with other low density support media such as spheres and toroids. It was therefore concluded that the large values of the air holdup achieved with the KMT® particles merit their application as a biomass support for high-rate aerobic biological treatment of industrial and municipal wastewaters.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call