Abstract
Polymer electrolyte membrane fuel cells (PEMFCs) are a growing technology that makes use of electrochemical energy for many practical applications. Energy is converted from electrochemical to electrical and thermal energy through the process of oxygen-reduction and hydrogen-oxidation, with water as a by-product. The performance of the fuel cell is heavily influenced by the mass transport capabilities of the water produced through this electrochemical reaction [1]. In order to understand the performance of specific fuel cell builds, it is important to develop a diagnostic tool which offers an accurate depiction of the amount of liquid water in the fuel cell during operation. Two of these diagnostic tools are electronic impedance spectroscopy (EIS) and synchrotron X-ray radiography. For this study, X-ray radiography was performed at the Biomedical Imaging and Therapy Bending Magnet (05B1-1) beamline at the Canadian Light Source Inc. (Saskatoon, Canada). In order to quantify the amount of liquid water in a PEMFC during operation, X-ray radiography was applied in the through-plane direction of the cell. Using the Beer-Lambert law, the processed images allowed for the liquid water to become visible in the anode and cathode flow channels, the anode and cathode gas diffusion layers (GDLs), the microporous layers (MPLs), as well as the membrane electrode assembly (MEA) [2]. EIS was used as a non-invasive diagnostic tool in quantifying the equivalent resistances of the fuel cell. This study aims to quantify the water saturation of various layers of the fuel cell during EIS measurements, and demonstrate the role of the water saturation of each layer to the overall mass transport resistance of the fuel cell, measured through EIS. The fuel cells analyzed have varying MPL thicknesses, as well as fuel cells without MPLs, at increasing constant current densities. Nyquist plots will be discussed with relation to amount of liquid water visualized. Figure Captions Figure 1. Subtracted in-plane image of the fuel cell with 150 μm-thick MPL. The image only shows 3 flow channels of 20.Figure 2. Nyquist plot of the fuel cell observed simultaneously with x-ray radiography 1.0 A/cm2.Figure 3. Water thickness profile plot at 1.0 A/cm2, from the image in Figure 1. Labeled from left to right: Anode GDL, Anode MPL, MEA, Cathode MPL and Cathode GDL.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.