Abstract
There is considerable industrial significance to understand the nature of subsurface deformation under the machined surface for correct prediction of surface properties in machined components based upon the machined conditions and material behaviors that give rise to them. In this study, high speed machining of Inconel 718 was carried with whisker reinforced ceramic cutting tool under different conditions of tool wear, coolant state and cutting parameters. The objective of the present investigation was to determine the effect of both cutting parameters and tool wear on the plastic deformation in the subsurface region of Inconel 718 after the finishing machining with above process conditions. The surface and subsurface region of machined specimens were examined using a high resolution scan electron microscope (HRSEM) and EBSD technique, microhardness measurements were also conducted on the test samples, accordingly plastic strain analysis were carried out.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
