Identification of Johnson-Cook material model parameters for laser shock peening process simulation for AA2024, Ti–6Al–4V and Inconel 718

Abstract

This paper addresses the identification of Johnson-Cook material model parameters for the simulation of high strain rate processes such as laser shock peening. A combined numerical and experimental approach is described for the identification of the material parameters for AA2024-T3, Ti–6Al–4V, and Inconel 718 alloys. Validation of the parameters was performed based on depth-resolved residual stress profile evaluation after both experimental and numerical laser shock peening application. However, it has been observed that the strain rate-dependent coefficient identified at low strain rates is insufficient for accurately representing the behavior of the Ti–6Al–4V alloy. Consequently, there is a need to identify and determine the appropriate parameter specifically tailored to the strain rates that are relevant to the intended application of the material. The outcomes of this study provide significant insights into the accurate identification of Johnson-Cook material model parameters for laser shock peening simulations. The findings emphasize the critical importance of considering the strain rate-dependent coefficient C in the Johnson-Cook material model to enhance the accuracy and precision of representing material behavior in simulation efforts.