Abstract
AbstractAr+ ion irradiation on low density polyethylene (LDPE), and polystyrene (PS) was performed in an O2 environment in order to improve wettability of polymers to water and to identify the formation of hydrophilic groups originated from chemical reactions on the surface of polymers. Doses of a broad Ar+ ion beam of 1 keV energy were changed from 5 × 1015 to 1 × 1017 /cm2 and the rate of the oxygen gas flowing near the sample surface was varied from 0 to 7 mi/min. The contact angle of polymers was not reduced much by Ar+ ion irradiation without oxygen gas. However, it dropped largely to a minimum of 35 ° and 26 ° for At+ ion irradiation in the presence of flowing oxygen gas on LDPE and PS, respectively. From x-ray photoelectron spectroscopy analysis, it was observed that hydrophilic groups were formed on the surface of polymers through an ion-assisted chemical reaction between the ion-induced unstable chains and oxygen. The newly formed hydrophilic group was identified as -(C=O)- bond and -(C=O)-O- bond. The contact angle of polymer was greatly dependent on the hydrophilic group formed on the surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
