Abstract
The paper proposes an identification method of high frequency loads based on statistical energy analysis theory. The load identification problems of structures subjected to multi excitations are classified into three cases according to the completeness of loads location information and subsystem response set, and the corresponding identification schemes are presented. The approaches for the derivation of load power spectrum from input power are described as well under the assumptions of constant value and linear variation on load power spectrum within each analytical frequency band. The simulated and experimental studies of load identification with the approach were conducted on a plate–shell assembled structural system. The results show that the input power of loads can be identified accurately in three cases using the presented identification method. Besides that, the computed load power spectrums under the constant value assumption have reasonable agreements with the measured load power spectrums.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.