Identification of Breakout Behind Casing: Methodology to Obtain Openhole-Equivalent Caliper Measurements Through Slotted Liner Using the Density Tool

Abstract

Growth in the coal seam gas industry in Queensland, Australia, has been rapid over the past 15 years, with greater than USD 70 billion invested in three liquified natural gas export projects supplied by produced coal seam gas. Annual production is of the order of 40 Bscm or 1,500 PJ, with approximately 80% of this coming from the Jurassic Walloon Coal Measures of the Surat Basin and 20% from the Permian Coal Measures of the Bowen Basin. The Walloon Coal Measures are characterized by multiple thin coal seams making up approximately 10% of the total thickness of the unit. A typical well intersects 10 to 20 m of net coal over a 200- to 300-m interval, interbedded with lithic-rich sandstones, siltstones, and carbonaceous mudstones. The presence of such a significant section of lithic interburden within the primary production section has led to a somewhat unusual completion strategy. To maximize connection to the gas-bearing coals, uncemented slotted liners are used; however, this leaves fluid-sensitive interburden exposed to drilling, completion, and produced formation fluids over the life of a well. External swellable packers and blank joints are therefore used to isolate larger intervals of interburden and hence minimize fines production. Despite these efforts, significant fines production still occurs, which leads to the failure of artificial lift systems and the need for expensive workovers or lost wells. Fines production has major economic implications, with anecdotal reports suggesting up to 40% of progressive cavity pump artificial lift systems in Walloon Coal Measures producers may be down at any one time. The first step in solving this problem is to identify the extent and distribution of fines production. The wellbore completion strategy above, however, precludes the use of mechanical calipers to identify fines-production-related wellbore enlargement. A new caliper-behind-liner technique has therefore been developed using a multiple-detector density tool. Data from the shorter-spacing detectors are used to characterize the properties of the liner as well as the density of the annular material. This is particularly important to evaluate as the annulus fill varies between gas, formation water, drilling and completion fluids, and accumulated fines. The longer-spacing detector measurements are then used in conjunction with pre-existing openhole formation density measurements to determine the thickness of the annulus, and hence hole size, compensating for liner and annulus properties.