Abstract
Liquid–liquid two-phase flow in microchannels is capable of boosting the heat removal rate in cooling processes. Formation of different two-phase flow patterns which affect the heat transfer rate is numerically investigated here in a T-junction containing water-oil flow. For this purpose, the finite element method (FEM) is applied to solve the unsteady two-phase Navier–Stokes equations along with the level set (LS) equation in order to capture the interface between phases. It is shown that the two-phase flow pattern in microchannels depends on the flow initial condition which causes hysteresis effect in two-phase flow. In this study, the hysteresis is observed in flow pattern and consequently in the heat transfer rate. The effect of wall contact angle on the hydrodynamics and heat transfer in the microchannel is investigated to gain useful insight into the hysteresis phenomenon. It is observed that the hysteresis is significant in super-hydrophilic microchannels, while it disappears at the contact angle of 75°. The effect of water to oil flow rate ratio (Qwat/Qoil) on the heat transfer is also studied. The flow rate ratio has a negligible effect on the Nusselt number (Nu) in the dripping regime, while the Nu decreases with an increase of Qwat/Qoil in the co-flow regime. The thickness of the oil film, velocity, and temperature distribution are studied in the co-flow regime. It is revealed that the normalized slip velocity reduces at higher values of Qwat/Qoil, which causes a reduction in the averaged Nu. In dripping regimes, higher flow rate ratios lead to a more frequent generation of droplet/slugs at a smaller size. The passage of the slugs or droplets increases the local Nu. Larger droplets generated at lower flow rate ratios cause a larger increase in the local Nu than smaller droplets. The temperature and velocity field around the droplets are also illustrated to investigate the heat transfer improvement. The generated vortex at the tip of the oil jet causes an increase in the velocity and Nu on the water side.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.