Abstract
The diesel oxidation catalyst (DOC) plays a key role in diesel exhaust treatment systems. Typical noble metals used as active components are platinum (Pt) and palladium (Pd). During lightoff/lightout experiments, the catalyst reactivity during heating is in some cases different from the reactivity during cooling in the same reaction mixture. These so called hysteresis phenomena have repeatedly been reported for CO, NO, and HC conversion and are mostly attributed to noble metal oxidation and/or surface coverage effects. Hauff et al. have developed a kinetic model that is able to account for the hysteresis effects observed in NO conversion on Pt-only catalysts due to noble metal oxidation. The model was only validated for a limited range of NO concentrations and temperatures. In this follow-up, further experiments on Pt-only as well as on Pd-only catalysts will be presented for additional feed compositions. General transferability of the Pt-only model to Pd-only catalysts for NO-only is demonstrated. By addition of CO and propene to the feed, additional hysteresis phenomena are observed and will be discussed. On Pd–only, results indicate that under lean exhaust conditions, the noble metal can only be slightly reduced by CO. Interestingly, with a mix of CO and NO no reactivation is observed whereas the combination of CO, NO, and propene again shows reducing tendency. Based on these informations, a possible modeling approach will be proposed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.