Abstract
For hypoid gear which processed by HFT (hypoid gear formate tilt) method, geometry parameters and machining parameters of hypoid gear were calculated by using Gleason card. According to the actual machining process and meshing principle, tooth surface equation was derived by coordinate transformation. Then the discrete coordinates points of tooth surface were obtained by using MATLAB tools and projection transformation principle, and data were saved in ibl format. At last the 3-demensional model of hypoid gear were established by importing the ibl format data in Pro/e.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
