Hypoid Gear Drives

Abstract

INTRODUCTION Hypoid gear drives have found a broad application in the automotive industry for transformation of rotation between crossed axes. Enhanced design and generation of hypoid gear drives requires an approach based on the ideas discussed for spiral bevel gears (see Chapter 21). The contents of this chapter are limited to (i) design of pitch cones, (ii) pinion and gear machine-tool settings, and (iii) equations of pinion–gear tooth surfaces. Design of pitch cones for hypoid gears was the subject of research performed by Baxter [1961], Litvin et al . [1974, 1990] and Litvin [1994]. Details of determination of machine-tool settings for manufacture of hypoid gears are given in Litvin & Gutman [1981]. AXODES AND OPERATING PITCH CONES Spiral bevel gears perform rotation about intersected axes, and their axodes are two cones (Section 3.4). The line of tangency of these cones is the instantaneous axis of rotation in relative motion. In the case of standard spiral bevel gears, the gear axodes coincide with the pitch cones. Hypoid gears perform rotation about crossed axes, the relative motion is a screw motion, and instead of the instantaneous axis of rotation we have to consider the instantaneous screw axis s − s (Section 3.5). The gear axodes are two hyperboloids of revolution that are in tangency along the axis of screw motion s − s (Fig. 3.5.1). The hypoid pinion–gear axodes (the hyperboloids of revolution) perform in relative motion rotation about and translation along s − s .