Abstract

The present study consisted in determining the effects of a hygrothermal treatment on wood fibers from the Laureliopsis philippiana Looser species. The fibers were treated in autoclave at 150 °C for 90 minutes at a pressure of 430 kPa, which was generated during the evaporation process of the water in autoclave. Physical properties, color, and water retention capacity of hygrothermically treated and untreated fibers were analyzed. The chemical properties determined were the extractable amount in sodium hydroxide, toluene ethanol, hot and cold water, the cellulose, holocellulose and lignin contents, the pH value, the percentage of volatile and washable acids, and the buffer capacity. In hygrothermically treated fibers, a change of color was detected as well as a reduction in the water retention capacity and an increase in the percentage of extractable, cellulose, lignin and a decrease of holocellulose. Also an increase in acidity, amount of volatile and washable acids and buffer capacity were determined. Due to the chemical changes observed in the treated fibers, these would present advantages in the manufacture of fiberboards, facilitating the setting of the amino resins.

Highlights

  • The present study consisted in determining the effects of a hygrothermal treatment on wood fibers from the Laureliopsis philippiana Looser species

  • The chemical properties determined were the extractable amount in sodium hydroxide, toluene ethanol, hot and cold water, the cellulose, holocellulose and lignin contents, the pH value, the percentage of volatile and washable acids, and the buffer capacity

  • Considering the changes in the physical and chemical properties of wood due to heat treatments, and its potential impact on production of boards, the aim of this study was to determine the effects of a hygrothermal treatment on fibers from L. philippiana, a species with unfavorable chemical characteristics for the production of boards with ureaformaldehyde (Pinto and Poblete, 1992; Poblete and Pinto, 1993)

Read more

Summary

Introduction

The higher the temperature and the exposure time of heat treatment, the lower the amount of water absorbed by the wood (Poblete, 1983; Kartal et al, 2007.). Using an autoclave generates pressure, which has effects that can be important in regards to the composition, structure and properties of wood (Giebeler, 1983; Ding et al, 2011.). These treatments cause an improvement in certain physical properties (Burmester, 1973)

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call