Abstract

Zinc (Zn)–manganese dioxide (MnO2) rechargeable batteries have attracted research interest because of high specific theoretical capacity as well as being environmentally friendly, intrinsically safe and low-cost. Liquid electrolytes, such as potassium hydroxide, are historically used in these batteries; however, many failure mechanisms of the Zn–MnO2 battery chemistry result from the use of liquid electrolytes, including the formation of electrochemically inert phases such as hetaerolite (ZnMn2O4) and the promotion of shape change of the Zn electrode. This manuscript reports on the fundamental and commercial results of gel electrolytes for use in rechargeable Zn–MnO2 batteries as an alternative to liquid electrolytes. The manuscript also reports on novel properties of the gelled electrolyte such as limiting the overdischarge of Zn anodes, which is a problem in liquid electrolyte, and finally its use in solar microgrid applications, which is a first in academic literature. Potentiostatic and galvanostatic tests with the optimized gel electrolyte showed higher capacity retention compared to the tests with the liquid electrolyte, suggesting that gel electrolyte helps reduce Mn3+ dissolution and zincate ion migration from the Zn anode, improving reversibility. Cycling tests for commercially sized prismatic cells showed the gel electrolyte had exceptional cycle life, showing 100% capacity retention for >700 cycles at 9.5 Ah and for >300 cycles at 19 Ah, while the 19 Ah prismatic cell with a liquid electrolyte showed discharge capacity degradation at 100th cycle. We also performed overdischarge protection tests, in which a commercialized prismatic cell with the gel electrolyte was discharged to 0 V and achieved stable discharge capacities, while the liquid electrolyte cell showed discharge capacity fade in the first few cycles. Finally, the gel electrolyte batteries were tested under IEC solar off-grid protocol. It was noted that the gelled Zn–MnO2 batteries outperformed the Pb–acid batteries. Additionally, a designed system nameplated at 2 kWh with a 12 V system with 72 prismatic cells was tested with the same protocol, and it has entered its third year of cycling. This suggests that Zn–MnO2 rechargeable batteries with the gel electrolyte will be an ideal candidate for solar microgrid systems and grid storage in general.

Highlights

  • Research into making alkaline zinc (Zn)–manganese dioxide (MnO2 ) batteries rechargeable has recently gained interest because these batteries are environmentally friendly, safe and the raw materials used are cheap and abundant

  • The delta-MnO2 was considered to be irreversible in the past because of the uncontrollable conversion reactions involving Mn3+ and Mn2+ ions, so much of the work was concentrated on making the 1e− proton-insertion reaction rechargeable to 10% to 50% of its theoretical capacity (308 mAh/g) [21,22]

  • The hydrogels or polymer electrolytes reported in the literature are free-standing films that are placed on electrodes of low areal capacity and cycled

Read more

Summary

Introduction

Research into making alkaline zinc (Zn)–manganese dioxide (MnO2 ) batteries rechargeable has recently gained interest because these batteries are environmentally friendly, safe and the raw materials used are cheap and abundant. The delta-MnO2 was considered to be irreversible in the past because of the uncontrollable conversion reactions involving Mn3+ and Mn2+ ions, so much of the work was concentrated on making the 1e− proton-insertion reaction rechargeable to 10% to 50% of its theoretical capacity (308 mAh/g) [21,22]. Very few reports have tried to understand the relationship between the utilization of Zn and MnO2 ’s theoretical capacity with the type of hydrogel (non-crosslinked and crosslinked) used in the battery. In this manuscript, we comprehensively report on the fundamental mechanisms, performance improvements and commercialization aspects of using a hydrogel in a rechargeable Zn–MnO2 battery.

Experiment
Electrode Fabrication
Electrolyte Preparation
Battery Fabrication
Electrochemical Experiment and Characterization
Electrochemical
Conductivity
Conductivity Measurements
In Situ Polymerization Process and Hydrogel Development
Measurement
Electrochemical Performance
Testing of Hydrogel-Containing Cells That Are Commercially Sized
Testing of Hydrogel‐Containing Cells That Are Commercially Sized
Overdischarge and Commercial
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call