Abstract
Hydrophilization of polydimethylsiloxane–urea copolymer (PSU) surfaces and the extent of hydrophobic recovery were investigated as a function of; (i) UV/ozone (UV/O) exposure time, (ii) the aging period after UV/O exposure, (iii) sample preparation method, and (iv) polydimethylsiloxane (PDMS) soft segment molecular weight of the copolymer (1500, 3000 and 11,000 g/mol). All copolymers had a constant urea hard segment content of 15% by weight. Samples were prepared by three different methods, which were; solution casting, spin-coating and electrospinning. XPS spectra clearly showed transformation of PDMS into SiO2 and sub-oxides, which increased gradually with increasing UV/O exposure time. XPS and ATR-FTIR measurements also revealed that the copolymer based on PDMS-11000 displayed the highest amount of SiO2 formation and overall surface modification. Static water contact angle values of the spincoated silicone–urea copolymer films decreased significantly from 110° to 43° after 3 h of UV/O exposure. Interestingly, the hydrophobicity of the electrospun fibers was retained under similar UV/O exposure conditions, most probably due to the preserved surface roughness. Hydrophobic recovery was evaluated after 2 months of storage at ambient conditions. The slowest recovery was observed for spin-coated copolymer film based on PDMS-11000, due to higher amount of surface oxidation and formation of a thicker SiO2 barrier layer.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
