Hydrogen-induced cracking behaviors of Ni–Cr–Mo-based superalloy fabricated by wire arc additive manufacturing under different solution temperature

Abstract

The hydrogen embrittlement behavior of Ni–Cr–Mo-based superalloy fabricated by wire arc additive manufacturing (WAAM) with or without solution treatment was investigated by electrochemical hydrogen charging. The results show that the dissolution of the Laves phase promotes the precipitation of the δ phase in the matrix of WAAM superalloy after solution treatment at 980 °C. When the solution temperature goes up to 1080 °C, the large Laves phase disappears and only MC exists in the matrix. The interfaces between the Laves phase/δ phase and matrix generally could act as hydrogen traps, which would reduce the motion of hydrogen and lead to high hydrogen embrittlement resistance of the WAAM and ST-980 °C samples. However, hydrogen mainly accumulates on grain boundaries in the ST-1080 °C due to the disappearance of the Laves phase and δ phase. Hydrogen-induced intergranular brittle fracture occurs during the slow strain rate tensile test and the ST-1080 °C samples exhibit higher hydrogen embrittlement susceptibility than that of the WAAM and ST-980 °C samples.