Abstract

Hydrogen-enriched reduced graphene oxide (RGO) was achieved using double-oxidized graphene oxide (GO2) as an anode in high-performance lithium batteries is reported. GO2 exhibited a much lower carbon-to-oxygen ratio, lower crystallinity, higher Brunauer–Emmett–Teller surface area, higher pore volume, and higher porosity as compared to graphene oxides produced using the typical modified Hummer’s method (GO1). The two forms of GO were reduced using two different reduction methods: supercritical isopropanol (scIPA) and heat treatment. The four types of RGOs synthesized using GO1/GO2 and scIPA/heat treatment exhibited significantly different chemical, morphological, and textural properties. The galvanostatic charge–discharge properties were highly dependent on the physicochemical properties of the RGOs. The scIPA-reduced GO2 exhibited superior electrochemical performance as compared to the thermally reduced GO1/GO2 and scIPA-reduced GO1. Highly reversible capacity (1331 mAh g–1 at 50 mA g–1 after 100 cycles),...

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.