Abstract
Crack propagation behavior of SCM440H low-alloy steel enhanced by absorbed hydrogen is investigated. Six materials tempered at different temperatures are used. Effects of stress ratio, loading frequency, hold time and material hardness on the crack propagation rate are examined under long-term varying load. Tests have been performed under continuous hydrogen charging, in which the crack tip has been isolated from the electrolyte and kept dry. An acceleration of crack propagation rate about six times compared to the uncharged material is found in all materials. In addition to this, however, an unexpected acceleration of crack propagation up to 1000 times is experienced under certain conditions. In materials with Vickers hardness higher than 280 tested at low frequency, the above marked acceleration is experienced. The crack surface morphology is quasi-cleavage. This critical hardness ( HV = 280) is a little lower than the usually accepted critical hardness for delayed failure ( HV = 350). In material with Vickers hardness lower than 268, however, such a marked acceleration is not experienced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.