Hydrodynamic and mass transfer efficiency of ceramic foam packing applied to distillation

Abstract

In addition to a high void volume and specific area, solid foams possess other properties (low density, good thermal, mechanical, electrical, and acoustical behaviour) that make them attractive for applications such as heat exchangers and reformers. Applications using foams as catalysts or structured catalyst supports have demonstrated higher performance than classical catalysts. Several studies have explored the hydrodynamic behaviour of foams in monophasic and countercurrent systems and have reported very low pressure drops. This paper describes the application of ceramic foam to distillation. The β-SiC foam contains 5 pores per inch (PPI) with a 91% void volume and a surface area of 640 m 2/m 3. Performance parameters including pressure drop for the dry and wet packing, flooding behaviour, and dynamic liquid hold-up were measured in a column of 150 mm internal diameter. The mass transfer efficiency in terms of the height equivalent to theoretical plate (HETP) was determined by total reflux experiments using a mixture of n-heptane and cyclohexane at atmospheric pressure. The experimental results were used to develop a set of correlations describing pressure drop and liquid hold-up in terms of a dimensionless number. The hydrodynamic performance and mass transfer efficiency were compared with classical packing materials used in distillation.