Abstract
To obtain more information on the hydraulic properties of membrane interface, the fiber Bragg grating (FBG) sensing technology was imported to investigate the effect of feed solution (FS) flow rate, draw solution (DS) flow rate and cross-flow direction on the membrane flux and membrane shear-force distribution of forward osmosis (FO) process. Results from experimental work demonstrated that a non-uniform spatial variation of the shear-force distribution exists along the membrane, and higher shear force is distributed in the middle position which resulted in higher diffusion load on the particular location of the membrane rind. Besides, increasing the inlet flow simply to a certain value didn't result in a higher shear force and lower the effect of concentration polarization (CP). Compared to co-current mode, counter-current mode showed the better hydraulic characteristics of higher shear-force, faster scouring frequency and consistent shear-force distribution, which will enhance the utilization of membrane and exhibit higher flux by increasing the inlet flow. Moreover, with the increase of FS and DS flow, the stress distribution showed more uniformed. Higher FS flow is more beneficial to FO process which will reduce ECP and improve flux in comparison to increasing DS flow which will produce adverse influence on ICP and diminish flux.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
