Hydraulic Performance Evaluation of Low-Cost Gravity-Fed Drip Irrigation Systems Under Constant Head Conditions

Abstract

The use of drip irrigation for upland crop production has gained popularity in developing countries due to its relatively high water-use efficiency. To maximize the efficiency of this irrigation method, it is important to evaluate its hydraulic performance in terms of emitter discharge and water distribution uniformity under various operating heads. In this study, the hydraulic performance of two locally available low-cost drip irrigation kits -referred to in this study as Drip Kit A and Drip Kit B - was assessed and compared under constant head conditions. Both drip kits are composed of a 1000-L intermediate bulk container (IBC) tank, 10-m submain line, 20-m lateral lines spaced 0.75 m apart, and cascade labyrinth emitters spaced 0.30 m apart along the laterals. Operating heads of 2.5, 3.5, 4.0, 4.5, 5.0, 5.5 m were used and maintained throughout the trials with the use of an overflowing tank. The submain and lateral lines were levelled (0% slope). Sampling of discharge rates was done for one-third of the total number of emitters for each of the tests performed. Results showed that the overall system emitter discharge rate generally increases with increasing operating head. Moreover, emitters farther from the submain line generated relatively lower discharge rates than those closer to it. Analysis of the experimental data showed that the Christiansen’s coefficient of uniformity (CU), emission uniformity (EU), and coefficient of variation (CV) ranged from 97.5 to 98.5, 95.9 to 97.7, and 0.02 to 0.04 for the drip systems tested. Further statistical analysis also showed that varying the operating heads does not have a statistically significant effect (α=5%) on the CU, EU, and CV of the system. Based on the results, Drip Kit B performed better than Drip Kit A in terms of water distribution uniformity. However, the latter could generate higher emitter discharge rates than the former. For both drip kits, an operating head of 2.5-m is recommendable for a 200 m2 plot, from the practical standpoint. This study has generated important empirical data that could serve as a basis for maximizing the performance efficiency of locally available drip irrigation systems for a more efficient irrigation water management.