Abstract
The problem considered is that of flow in the two parallel channels formed by the introduction of a long thin plate into a duct of uniform rectangular cross section. The plate is slightly inclined and does not, in general, span the channel so that transverse flow may occur. The flow is described by applying the one-dimensional approximation. Boundary conditions were established by regarding the stagnation streamline as defining two separate channels upstream of the plate leading edge. The solution was then obtained numerically with an IBM 650 computer. Computed hydraulic parameters were in good agreement with those obtained experimentally.
Full Text 
Sign-in/Register to access full text options
Sign-in/Register to access full text options 
Paper version not known
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
