Abstract
Abstract A mechanical pruner serves for pruning new hopvine shoots in spring. The later yield depends on the right timing and quality of pruning. That is why hop pruning is one of the most important agrotechnical procedures. A double-disc mechanical pruner used on high trellises cannot be used on low trellises due to its large size. Abroad, for pruning hops on low trellises a specially adapted sprinkler is used (chemical pruning). With regard to the effort to minimize the chemical environmental burden, we opted for the design of the mechanical pruner. Firstly, the low trellis, mechanical pruner, and also elements used in the design of hydraulic circuit are described. Next part of the paper is devoted to the input requirements for both the hydraulic circuit and the mechanical pruner designs. Then a description of an adapted inter-axle carrier used for the experimental model of the hop mechanical pruner and of the effected field measurement follows, along with interpretation of the measured data. These data are depicted in clearly arranged graphs showing the dependency of pressure and hydraulic oil flow on the cutting disc rotational frequency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.