Abstract
Abstract Solar energy is the most effective substitute for fossil fuels when it comes to Produce electricity among the numerous renewable energy sources. The efficiency may drop as a result of overheating, and the PV cell may also be harmed. Therefore, increasing the output of a solar PV system at a lower cost is essential to improving its efficiency. Additionally, by using cooling methods, the PV cells’ lifetime is extended. By lowering the working temperature of a PV panel’s surface, you may increase efficiency and slow the thermal deterioration rate. This may be done by module cooling and lowering the heat that the PV cells generate while operating. Hence, an active cooling technology known as optimization-aided water spraying technique is employed to increase efficiency. This method enables the PV panels to provide their maximum output power while taking less time to drop down to a lower surface temperature. Beluga Whale assisted Jellyfish Optimization (BWJO) model is suggested as a means of achieving these goals. Finally, Simulink/MATLAB is used to implement the suggested method and optimize the PV system cooling. The performances of the two components were compared using a variety of metrics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.