Abstract
This paper proposes an approach for modeling the wind turbines and designing a control methodology. Look up table of the optimal power is achieved based on maximum power point tracking (MPPT) profile for maximizing system effectiveness. A 5*2 MW and 690 V wind farm connected with IEEE 14 bus network is the suggested system. The wind energy conversion systems (WECS) are associated with the network through Voltage Source Converters (VSC). The doubly-fed induction generator (DFIG) is used, due to its ability to work at multiple operational speeds. DFIG vector control model is used for the system performance validation. Pitch angle control methodology is used for regulating the mechanical power at high wind velocity. The controller dynamic range for both wide speed changes and line faults is significantly achieved. An acceptable output power is obtained using this system for wide speed range. The MATLAB/Simulink software is used to construct a model of wind farm and the utilized public network.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Recent Technology and Engineering (IJRTE)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
