Abstract
In this work, hybrid composites were produced by blending oil palm fibers with coir fibers and high-density polyethylene for fixed fiber content (40 wt%). The composites were manufactured by twin-screw extrusion followed by compression molding. In particular, the effect of coupling agent (maleated polyethylene) concentration (0, 2, and 4 wt%) was investigated. From the composites obtained, the morphological, structural, and thermal properties were evaluated via scanning electron microscopy, Fourier transformed-infrared spectrometry, and thermogravimetric analysis. The effect of fiber ratio and compatibilization on mechanical performances was studied in tension, flexion, torsion, and impact. The results showed that the compatibilized composites have better fiber dispersion/distribution (homogeneity) due to chemical bonding leading to good interfacial adhesion. All the mechanical properties increased with the presence of fibers and compatibilizer, with non-hybrid composites of coir and oil palm fibers exhibiting the highest and lowest moduli, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.